JEFFTRON MOSFET II WITH WIRES (JT-MOS-W2)

PROFESSIONALLY MADE MOSFET FOR AIRSOFT ELECTRIC RIFLES.
THE DEVICE INCREASES THE REPLICA'S RATE OF FIRE AND THE BATTERY LASTS LONGER COMPARED TO BASIC WIRING.

SPECIFICATIONS:
– PRE-SOLDERED WIRES ALLOW QUICKER AND EASIER INSTALLATION IN THE AIRSOFT REPLICA, IT IS LONG ENOUGH FOR ALL TYPES OF WEAPONS. JUST CUT THE WIRES TO THE REQUIRED LENGTH AND CONNECT THE CONNECTORS (INCLUDED IN THE PACKAGE)
– FOUR HIGH-QUALITY 1.5QMM (AWG16) POWER WIRES COVERED WITH MPPE INSULATION AND TWO 0.34QMM (AWG22) SIGNAL WIRES ARE PRE-SOLDERED ON THE DEVICES
– BOARD COVERED WITH PROTECTIVE COATING, PROTECTS THE DEVICE FROM WATER
– IF YOU WISH TO USE YOUR OWN WIRES, CHOOSE THE VARIANT WITHOUT WIRING
– DESIGNED FOR SPRINGS UP TO M210 (EQUIVALENT FOR SINGLE SHOT CURRENT OF 150A OR BURST FIRE OF 50A FOR MAX. 30 SECONDS)
– SPECIFIED FOR COMMON BATTERIES UP TO 17V (NI-XX 8.4 – 12V, LI-PO 7.4 – 14.8V)
– 6-WIRE CONNECTION
– DEVICE DIMENSIONS 25mm X 12mm X 7mm
– NO CURRENT CONSUMPTION IN IDLE MODE
– NO SPARKS ON SWITCH CONTACTS
– IN AUTOMATIC FIRE MODE, THE PISTON STOPS IN A RANDOM POSITION DUE TO THE MECHABOX DESIGN
– FOR PROPER OPERATION IT IS NECESSARY TO HAVE A FUNCTIONAL CUT OFF LEVER, SELECTOR PLATE, REVERSE LATCH, TRIGGER AND TRIGGER LOCK, AS IN A STANDARD GEARBOX

DEVICE INSTRUCTIONS: YOU CAN DOWNLOAD THE INSTALLATION MANUAL IN ENGLISH HERE [PDF, 685.43 KB]

PACKAGING:
– DEVICE WITH WIRING
– MALE DEANS CONNECTOR
– 30A MINI FUSE
– 4X FEMALE FASTON 2,8mm
– 6X BLACK HEAT SHRINK TUBE 3,2mm – LENGTH 20mm
– 3X BLACK HEAT SHRINK TUBE 4,8mm – LENGTH 20mm
– INSTALLATION MANUAL IN ENGLISH

WARNING: THE INSTALLATION OF THIS DEVICE IS ENTRUSTED TO AN EXPERT, WHO MIGHT SOLDER AND DISASSEMBLE THE AIRSOFT GUN. NEVER USE A SOLDERING GUN!