PERUN V2 HYBRID FRONT CABLES (HB-V2-FW)

PERUN V2 HYBRID FRONT CABLES
REPLACE THE MECHANICAL CONTACTS IN YOUR AIRSOFT REPLICA OR GEL BLASTER AND OFFERS MANY ADDITIONAL FEATURES
OPTICAL AND MAGNETIC SENSORS ELIMINATE MANY MOVING PARTS SUBJECT TO DAMAGE, THUS INCREASING RELIABILITY.
ADAPTIVE TRIGGER CONTROL ALLOWS YOU TO SWITCH FROM VERY SHORT TO LONG TRIGGER TRAVEL EVEN IN THE FIELD, WITH ALMOST ALL TRIGGER TRAVELS, INCLUDING STOCK TRIGGER TRAVEL.
WORKS WITHOUT ANY MODIFICATION WITH MOST TOKYO MARUI STANDARD V2 GEARBOXES.
FOR DETAILS AND EXCEPTIONS PLEASE REFER TO THE MANUAL.

FEATURE LIST:
– Adjustable trigger sensitivityThe trigger can be set to 5 sensitivity levels, ranging from a very short pull, needed to fire a shot, to a very long one. No modifications to the trigger or gearbox are required, and trigger sensitivity can be adjusted even in the field.
– Independently programmed firing modes: Program the firing modes as you prefer, setting safe, semi, burst or automatic on both selector positions.
– Active brake: the active brake stops the engine after each shot, preventing spring compression or, in the case of high rate-of-fire replicas, overspin (double-shot problem).
– PrecockingA quick trigger response can be the difference between victory and defeat, especially in CQB situations. With precocking enabled, the piston will remain in the rear position after each shot with the spring already compressed, ensuring the next shot is fired immediately after pulling the trigger. To release the spring after using precocking, press the trigger and hold it for 2 seconds, after which a second shot will be fired, this time without precocking and fully braked.
– 2-stage triggerA light trigger pull produces a single shot or burst, while a deeper pull will produce a burst or fully automatic fire. The following modes are available: semi-burst, semi-auto, and burst-auto.
– Binary trigger: Allows you to easily perform double shots in semi-automatic mode. Once enabled, if semi-automatic fire is set, shots will fire not only when the trigger is pressed, but also when it is released.
– Rate of fire reduction: Reduce the rate of fire to automatic or burst fire to save ammo or make the replica fire more realistically.
– DMR fashion: Introduces intervals between semi-automatic shots to comply with DMR rules on some courses.
– Low battery voltage alarm: Dedicated to Li-Po and Li-Ion batteries. If the battery voltage drops to a dangerously low level, the user will be alerted by short beeps that repeat every minute. This can also be freely activated and deactivated.
– DSG: A sector gear detection mode specially prepared to work with dual sector gears.
– Diagnostic system: Constantly monitors the replica and the MOSFET itself. If there are any problems, it immediately informs you of the potential cause, making troubleshooting much easier.
– Electronic fuse: It will save your replica and battery in the event of a serious malfunction. It will automatically disconnect the battery when a short circuit or jammed motor is detected.

Programming of all settings is performed exclusively using quick and easily memorable sequences of fire selector switches and trigger pulls, supported by sound signals and multicolored LEDs. This allows you to change settings at any time, in seconds, even under enemy fire. All settings are set independently for each selector position, so you can program the MOSFET exactly as you want, such as semi-on to semi-on and binary trigger to auto.

The Perun V2 Hybrid works seamlessly with any battery from 7V to 17V. It can even be used with most extreme configurations.